Modelling and Optimization of a Solar Photovoltaic Harvesting System for Wireless Sensor Network Nodes

OLANIYI Segun Francis

Department of Electronic and Electrical Engineering, Faculty of Engineering and Technology, Ladoke Akintola University of Technology, Ogbomoso, Nigeria.

ADEBIYI Oluwaseyi Joseph *

Department of Electronic and Electrical Engineering, Faculty of Engineering and Technology, Ladoke Akintola University of Technology, Ogbomoso, Nigeria.

OGUNYEMI Joel

Department of Electrical and Electronic Engineering, Federal Polytechnic, Ilaro, Nigeria.

OJO Babajide Adelaja

Department of Electrical and Electronic Engineering, Federal Polytechnic, Ilaro, Nigeria.

ADEGBOLA Oluwole Abiodun

Department of Electronic and Electrical Engineering, Faculty of Engineering and Technology, Ladoke Akintola University of Technology, Ogbomoso, Nigeria.

*Author to whom correspondence should be addressed.


Abstract

Wireless sensor network (WSN) nodes are frequently deployed in remote and inaccessible environments, where finite-capacity batteries constrain network lifetime and increase maintenance requirements. This paper presents the modelling and optimisation of a solar photovoltaic (SPV) energy-harvesting system designed to provide reliable, efficient and cost-effective power for WSN nodes. A stochastic duty-cycle model was developed for five sensor nodes using sleep, sensing, transmitting and receiving states. The SPV array was represented with a single-diode current-voltage model, while a Perturb and Observe maximum power point tracking (MPPT) controller was implemented through a buck DC-DC converter. A reliability-constrained Particle Swarm Optimisation (PSO) framework was then used to determine the optimal SPV and battery capacities by minimizing life-cycle cost subject to energy-balance, battery state-of-charge and loss-of-power-supply-probability constraints. MATLAB/Simulink simulations showed that one node consumed an average current of 0.00282 A and an average power of 0.00931 W, with a peak instantaneous power of 0.1155 W. The optimal system for five nodes comprised a 0.7010 kW SPV array and a 2.5256 kWh battery, with a 25-year life-cycle cost of $4,843.76 and a loss of power supply probability of 0.04997. The MPPT configuration achieved 96.82% efficiency and a final battery state of charge of 92.96%, compared with 82.88% efficiency and 87.76% state of charge for pulse-width modulation control. The integrated framework provides a practical basis for designing autonomous SPV-powered WSN deployments in remote and energy-constrained environments.

Keywords: Wireless sensor network, solar photovoltaic, maximum power point tracking, particle swarm optimization, energy harvesting


How to Cite

Francis, OLANIYI Segun, ADEBIYI Oluwaseyi Joseph, OGUNYEMI Joel, OJO Babajide Adelaja, and ADEGBOLA Oluwole Abiodun. 2026. “Modelling and Optimization of a Solar Photovoltaic Harvesting System for Wireless Sensor Network Nodes”. Journal of Engineering Research and Reports 28 (11):170-80. https://doi.org/10.9734/jerr/2026/v28i112050.

Downloads

Download data is not yet available.