Multi-Hole Process Plate Modification for Chip on Lead Device at Die Attach Process
Journal of Engineering Research and Reports,
The paper focused on the improvement done in chip on lead (COL) leadframe package assembly manufacturing to address the leadframe bouncing effect during die attach process. A new and enhanced process plate is designed with multi-hole configuration to provide a strong vacuum underneath the leadframe and to maintain the planarity during dispensing and die bonding of silicon dies onto the leadframe. With the new multi-hole process plate, leadframe bouncing was successfully eliminated during die attach process. For future works, the multi-hole process plate could be used on devices with similar configuration.
- Chip on lead
- die attach
- leadframe bouncing
- process plate
- vacuum hole.
How to Cite
Saha S. Emerging business trends in the semiconductor industry. Proceedings of PICMET '13: Technology management in the IT-Driven services (PICMET) USA. 2013;2744-2748.
Xian TS, Nanthakumar P. Dicing die attach challenges at multi die stack packages. 35th IEEE/CPMT International Electronics Manufacturing Technology conference, Malaysia. 2012;1-5.
Yeap LL. Meeting the assembly challenges in new semiconductor packaging trend. 34th IEEE/CPMT International Electronic Manufacturing Technology Symposium (IEMT), Malaysia. 2010;1-5.
Nenni D, McLellan P. Fabless: The transformation of the semiconductor industry. CreateSpace Independent Publishing Platform, USA; April 2014.
Doering R, Nishi Y. Handbook of semiconductor manufacturing technology. 2nd ed., CRC Press, USA; July 2007.
Geng H. Semiconductor manufacturing handbook. 2nd ed., McGraw-Hill Education, USA; September 2017.
Graycochea Jr. E, et al. Warpage mitigation through diebond process improvement with enhanced leadframe configuration. Journal of Engineering Research and Reports. 2020;10(2);39-42.
Abdullah Z, et al. Die attach capability on ultra thin wafer thickness for power semiconductor. 35th IEEE/CPMT International Electronics Manufacturing Technology Conference, Malaysia: 2012;1-5.
Sumagpang Jr A, et al. Non-stick on pad defect reduction through clamp and insert design augmentation. Journal of Engineering Research and Reports. 2020;12(2);37-45.
Abdullah S, et al. Dicing die attach film for 3D stacked die QFN package. 32nd IEEE/CPMT International Electronic Manufacturing Technology Symposium. USA. 2007;73-75.
Abstract View: 229 times
PDF Download: 195 times